FOXBORO P0916QT

Welcome, thank you for your trust, The seller has more than $1526000 worth of industrial control products inventory.hope we can help you solve your problem!!!

  We Can transport to the world!!!

*******************************************************

Welcome, thank you for your trust, The seller has more than $1526000 worth of industrial control products inventory.hope we can help you solve your problem!!!

  We Can transport to the world!!!

*******************************************************

FOXBORO P0916QT IO module In Stock

General Description

The RTT20 I/A Series Temperature Transmitter is a microprocessor-based, two-wire device for 

converting various mV and ohm type sensors into a linear 4 to 20 mA or digital output. A standard two-wire system provides a nominal 24 V dc power to the transmitter and also carries the 

output signal to a receiver tied into the loop wiring. There are three different output types with 

communications capabilities as follows:

Output Code -I: 4 to 20 mA without remote communications

Output Code -T: 4 to 20 mA output with HART communication

Output Code -D: 4 to 20 mA or FoxCom™ digital communication

The microprocessor-based transmitter was designed for easy installation in a wide variety of applications. The major differences between the three output types is in communications. The 

optional 1-Line and 3-Line Indicator/Configurators are designed to enable the user to locally 

reconfigure any transmitter database. A single indicator can be easily moved from one transmitter 

to another. No tools are required to install or remove it. Simply plug it in and make the desired 

adjustments to the transmitter. Then remove it and move on to the next transmitter. The 4 to 

20 mA transmitter (Output Code -I) can only be adjusted using these Indicator/Configurators 

because there is no remote communications capability. Whenever the local Indicator/Configurators are used for reconfigurations, the loop must be put in manual. As a safety feature, the output 

will be held at the last value until the transmitter is returned to the operational mode. 

The HART and FoxCom protocol transmitters have an internal modem to enable the database to 

be remotely reranged or reconfigured as follows:

HART protocol – with a HART Communicator or a Foxboro PC-based configurator.

FoxCom protocol – with a PC-Based Configurator and/or from an I/A Series system.

All of the remote configurators can communicate with the transmitter from any wiring 

termination point in the loop. This allows the transmitter to be installed in hazardous locations or 

areas which are not at grade level. The configurator can only be used in an area for which it is 

rated. Communication between the remote configurator and the transmitter is based upon the 

Frequency Shift Keying (FSK) technique. Since the FSK tones do not add any current to the twowire system, reading transmitter data does not interfere with the output signal. When new 

configuration data is being downloaded into the transmitter, however, the output is interrupted 

and the loop must therefore be put in manual. The transmitter with FoxCom protocol can also be 

digitally integrated into an I/A Series System and reconfigured with any of the system 

workstations, eliminating the need for the separate configurator.

The microprocessor-based transmitter has been designed to accept a wide variety of mV and resistive sensors:

Product details:

FOXBORO P0916QT IO module

Contact information：

Contact person：Luna Chen

Email Address:：sales6@saulplc.com

WhatApp： +86 13358378970

We look forward to your inquiry and will get back to you as soon as possible.

We have the same series of models in stock. If you don't find the model you need, please contact us and we will provide you with an official quotation！